For quite some time I have observed a LOM warning in VMware health status tab on an HPE Proliant ML350 Gen10 server. It seems like it reports the warning on two NIC that are down, even though there are unused by ESXi.
Month: November 2018
A couple of days ago I was visiting a customer to setup their Lenovo host to run vSAN – after the initial setup of vSAN kernel IPs, disk groups and so on, I took a look at the “VSAN Health check” to make sure that everything was healthy and supported.
Under the “hardware compatibility” part all checkmarks where green, but the Controller firmware version was not detected – so I did found it a bit strange that it reports the disk controller as supported without knowing what version it actually was running.
This issue is not new to me, as I have seen it a couple of times before, but this time it was different after all.